It comes in two models: a 1-Liter version and a bigger 5-Liter one.
Both models can be used for development or small-scale production.
Their only limit is your imagination.
150ml to 1L
450ml to 5L
-20° to 200°
Vacuum 200 mbar
Max 5 bar
All matter matters.
We use Mettler Toledo' and Bürkert's equipment
to dose and load your reagents automatically.
You can load 3 liquids, 2 gases, and 1 solid at once.
If you need more, we can create a custom version for you.
A lab on your desk.
OnePot lets you save a lot of time. And space too.
Spot. The difference.
From the outside, the Spot looks like a simple cylinder.
Inside, it contains a set of sensors that capture data 150 times per second about temperature, density, and viscosity.
Beyond the sensors, each Spot contains multiple heating cells
to heat the reaction from the inside: more homogeneous heat distribution and less energy consumption.
Last but not least, the low-speed rotation of the Spots mixes the reagents without causing any vortices.
Everything but basic.
All OnePots are equipped with a Mettler Toledo state-of-the-art pH meter.
Its software is integrated into ours so that
you can manage it on one single platform.
And yet it moves.
Usually, you can't decide at which height liquids and gases
are loaded and extracted.
OnePot's nozzle moves according to your recipe to let you perform bubbling, emulsification, and whatever you can think of.
No Schlenk line? Fine!
OnePot works in a pressurized sealed environment.
This means you can create an inert atmosphere in seconds.
The OnePot monitoring system goes far beyond a typical lab device’s check light and can precisely detect fault states across the robot’s hardware, software, and firmware.
Thanks to predictive maintenance, you'll always have a running OnePot in your lab.